Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-67
Release Version 11-97
Removal and Replacement Procedures
RRP 3.10 MSI Friction Clutch (PL4.3)
Removal
1. Remove the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.
2. Remove the E rin
g
securin
g
the Clutch to the shaft.
3. Rotate the Clutch clockwise as
y
ou pull the it off of the shaft.
Replacement
1. Make sure the Spacer is in place on the Clutch shaft.
2. Rotate the Spacer so the tabs on the Spacer mesh with the notches on the Clutch Gear.
When performing step 3, push only on the rear of the Clutch. Never press the sides of the
Clutch. Pressing the sides of the Clutch will cause the Clutch break apart.
3. Slide the Friction Clutch onto the shaft, rotatin
g
the Clutch as
y
ou slide it toward the Spacer.
4. Make sure the Clutch and Spacer mesh.
5. Use one E rin
g
to secure the Clutch to the shaft.
6. Reinstall the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.