Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-59
Release Version 11-97
Removal and Replacement Procedures
RRP 3.6 MSI Feed Roll (PL4.3)
Removal
1. Remove the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.
2. Remove the screw securin
g
the MSI No-Paper Sensor Bracket
(
PL4.3.11
)
to the Feeder Assembl
y
,
and lift the Sensor Bracket out of the wa
y
.
3. Remove the KL clip securin
g
the MSI Feed Roll to the Feed Shaft, and slide the Feed Roll off of the
shaft.
Replacement
1. Position the Feed Roll so the metal end of the hole is facin
g
the No-Paper Sensor.
2. Press down the Retard Pad and slide the MSI Feed Roll onto the Feed Shaft.
3. Use a KL clip to secure the Roll to the shaft.
4. Reinstall the No-Paper Sensor Bracket onto the Feeder Assembl
y
, and use one screw to secure it to
the Assembl
y
.
5. Reinstall the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.