Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-57
Release Version 11-97
Removal and Replacement Procedures
RRP 3.5 MSI Feed Clutch (PL4.3)
Removal
1. Remove the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.
2. Remove the screw securin
g
the MSI Tra
y
Support
(
PL4.1.9
)
to the Feeder Assembl
y
, and pull the Sup-
port awa
y
from the Assembl
y
(
Fi
g
ure 1
)
.
3. Disconnect the J208 runnin
g
to the MSI Feed Clutch.
4. Remove the screw securin
g
the Rear Hook Bracket to the Feeder Assembl
y
and remove the Bracket
(
Fi
g
ure 2
)
.
5. Remove the E-rin
g
securin
g
the MSI Link Gear to the idler shaft, and slide the Gear, alon
g
with the
MSI Drive Gear Assembl
y
off of the shaft
(
Fi
g
ure 3
)
.
6. Remove the E-rin
g
securin
g
the MSI Feed Clutch to the Feed Shaft and slide the Clutch off of the Feed
Shaft
(
Fi
g
ure 4
)
.
Replacement
1. Position the MSI Feed Clutch with the
g
ear facin
g
out, and slide the Clutch onto the Feed Shaft.
2. Thread the Clutch wire harness throu
g
h the cutout in the Support frame.
3. Rotate the Clutch so the notch in the Clutch fits into the ke
y
in the Assembl
y
(
Fi
g
ure 4
)
.
4. Use and E-rin
g
to secure the MSI Feed Clutch to the Feed Shaft.
5. Reinstall the Link Sprin
g
onto the Rear Latch
(
Fi
g
ure 3
)
.
6. Slide the MSI Link Gear, alon
g
with the MSI Drive Gear Assembl
y
, onto the idler shaft.
7. Use an E-rin
g
to secure the MSI Link Gear to the idler shaft.
8. Reinstall the Rear Hook Bracket to the Feeder Assembl
y
, and use one screw to secure the Bracket.
9. Reconnect J208.
10. Reinstall the MSI Tra
y
Support and use a screw to secure it to the Feeder Assembl
y
.
11. Reinstall the MSI Tra
y
Assembl
y
(
RRP 3.2
)
.