Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-45
Release Version 11-97
Removal and Replacement Procedures
RRP 2.14 Tray 2 Take Away Roll Assembly (PL3.6)
Removal
1. Remove Tra
y
2 Retard Assembl
y
(
RRP 2.15
)
.
2. Remove the E rin
g
s and Gears attached to the rear of the Take Awa
y
Roll shaft.
3. Remove the Center Bearin
g
on the Take Awa
y
Roll Shaft, and slide the Roll out of the Retard Support.
Replacement
1. Reinstall the Take Awa
y
Roll shaft onto the Retard Support.
2. Reinstall the Center Bearin
g
onto the Take Awa
y
Roll shaft, and secure the shaft to the Support.
3. Reinstall the Gears and E rin
g
s to the rear of the Take Awa
y
Roll shaft.
4. Reinstall Tra
y
2 Retard Assembl
y
(
RRP 2.15
)
.