Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-41
Release Version 11-97
Removal and Replacement Procedures
RRP 2.12 Tray 2 Feed Clutch (PL3.5)
Removal
1. Remove the Rear Cover 1TM
(
RRP 1.6
)
.
2. Disconnect J240 from the Feed Clutch.
3. Remove the E rin
g
securin
g
the Clutch to the shaft, and slide the Clutch off of the shaft.
4. Remove the E rin
g
securin
g
the Gear to the shaft, and slide the Gear and Bearin
g
off of the shaft.
Replacement
1. Slide the Bearin
g
onto the shaft, and seat it in the cutout in the printer frame.
2. Slide the Gear onto the shaft, and use an E rin
g
to secure it to the shaft.
3. Slide the Feed Clutch onto the shaft, makin
g
sure the positionin
g
notch on the shaft hooks onto the tab
on the frame.
4. Use an E rin
g
to secure the Clutch to the shaft.
5. Reconnect J240 to the Feed Clutch.
6. Reinstall the Rear Cover 1TM
(
RRP 1.6
)
.