Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-35
Release Version 11-97
Removal and Replacement Procedures
RRP 2.9 Tray 1 & Tray 2 Level Sensors (PL3.1 & 3.4)
Use this procedure for removin
g
and replacin
g
the Paper Level Sensors for Tra
y
s 1 and 2.
Removal
1. Remove the Paper Tra
y
associated with the Paper Level Sensor
y
ou are
g
oin
g
to remove.
2. S
q
ueeze the Sensor latches and remove the Paper Level Sensor from the frame.
3. Disconnect the P/J from the Sensor.
Replacement
1. Reconnect the P/J to the Sensor.
2. Position the Sensor with the arms of the Sensor facin
g
the Feed Assembl
y
Actuator.
3. Reinstall the Paper Level Sensor into the slot in the frame b
y
first insertin
g
the front latch of the Sensor
throu
g
h the front openin
g
in the frame.
4. Press in on the rear latch and insertin
g
it into the rear openin
g
.
5. Release the rear latch and the Sensor snaps into place.
6. Release the Actuator and make sure it moves freel
y
between the arms of the Sensor.
7. Reconnect the P/J to the Sensor.
8. Reinstall the Paper Tra
y
.