Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-25
Release Version 11-97
Removal and Replacement Procedures
RRP 2.4 Tray 1 Take Away Roll Assembly (PL3.3) continued
Replacement
1. Reinstall Tra
y
1 Take Awa
y
Roll Assembl
y
onto the bottom of the printer frame.
2. Ali
g
n the two plastic mountin
g
pins, located on the top of the Assembl
y
, with the two mountin
g
holes
located in the bottom of the printer frame.
3. Press the Assembl
y
into the frame so the mountin
g
pins snap into the holes.
4. Use two screws to secure the front of the Assembl
y
to the printer frame.
5. Use four screws to secure the rear of the Assembl
y
to the printer frame.
6. Reinstall Tra
y
1 Feed Clutch, alon
g
with the Gear and Bearin
g
,
(
RRP 2.2
)
.
7. Reinstall the Support Assembl
y
Sprin
g
(
RRP 2.6
)
.
The following step has you lift the printer. The printer is very heavy and requires
two people to lift it. Do not attempt to lift the printer by yourself.
8. Set the printer onto Tra
y
2.
9. Reinstall Tra
y
1 Lift Motor
(
RRP 2.1
)
.
10. Reinstall the retainin
g
clip that is located under the Option Connector Bracket, and use one screw to
secure the clip
(
Fi
g
ure 1
)
.
11. Reinstall the Option Connector Bracket to the frame, and use one screw to secure the Bracket.
12. Reconnect P403, P404, P406, and P408 to the MCU PWB.
13. Reinstall the dockin
g
clip to Tra
y
2, and use one screw to secure the clip.
14. Reinstall the dockin
g
stud located at the lower ri
g
ht of the Tra
y
, and use a retainin
g
clip to secure the
stud.
15. Reinstall the MSI Support Assembl
y
(
RRP 3.3
)
.
16. Reinstall the Rear Cover Assembl
y
(
RRP 1.3
)
.
17. Reinstall the Left Upper Cover Assembl
y
(
RRP 4.2
)
.
18. Reinstall Tra
y
1 and Tra
y
2.
19. Reinstall the EP Cartrid
g
e
(
rRP 5.2
)
.
20. Reinstall the Duplex Unit, if one was installed
(
RRP 12.1
)
.