Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-21
Release Version 11-97
Removal and Replacement Procedures
RRP 2.3 Feed, Nudger, and Retard Rolls (PL3.2 ~ 3.6)
Use this procedure for Feeders 1 and 2.
Replace the Feeder, Nudger, and Retard Rolls as a unit.
Removal
1. Remove the paper tra
y
from the appropriate feeder.
2. Press in on the front of the Chute, and remove the Chute.
3. Pull out on the Roll latch and slide the Roll off of the shaft.
4. Repeat step 3 for the remainin
g
two Rolls.
Replacement
1. Position the Roll with the latch end facin
g
out, and slide the Roll onto the shaft.
2. Rotate and push the Roll down the shaft until the latch locks the Roll into place.
3. Repeat steps 1 and 2 for the remainin
g
two Rolls.
4. Reinstall the Chute b
y
slidin
g
the openin
g
in the rear of the Chute into the tab on the frame, then
sli
g
htl
y
s
q
ueezin
g
the Chute and hookin
g
the tab at the front of the Chute into the openin
g
on the
frame.
5. Reinstall the paper tra
y
.
6. Reset the Paper Feeder Usa
g
e Lo
g
for the feeder with the new Rolls.
a. Enter Dia
g
nostics.
b. Enter either 30-6
(
Tra
y
1
)
, 30-7
(
Tra
y
2
)
.
c. Press
[
4
]
to view the lo
g
.
d. Use the Control Panel ke
y
s to set each di
g
it of the displa
y
ed lo
g
number to 0.
e. Exit Dia
g
nostics.