Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-19
Release Version 11-97
Removal and Replacement Procedures
RRP 2.2 Tray 1 Feed Clutch (PL3.2)
Removal
1. Remove the Rear Cover
(
RRP 1.3
)
.
2. Open the Duplex Unit.
3. Open the Left Upper Cover.
4. Disconnect J202 from the Tra
y
1 Feed Clutch.
5. Remove the E rin
g
that is securin
g
the Feed Clutch to the shaft.
6. Slide the Feed Clutch awa
y
from the printer frame, then rotate the Clutch until
y
ou have enou
g
h clear-
ance from the Support Sprin
g
to slide the Clutch completel
y
off of the shaft.
Replacement
1. Position the Feed Clutch over the end of the Feed Shaft.
2. Reposition the Feed Clutch so it fits the ke
y
notch on the shaft and
y
ou can feel the Clutch slide onto
the shaft, and press the Clutch onto the shaft until the Clutch P/J clears the Support Sprin
g
.
3. Rotate the Clutch until the slot in the Clutch lines up with the ke
y
on the frame.
4. Press the Clutch onto the shaft until it stops, and make sure the ke
y
on the frame is in the slot in the
Clutch.
5. Use an E rin
g
to secure the Clutch to the shaft.
6. Reconnect J202 to the Feed Clutch.
7. Reinstall the Rear Cover
(
RRP 1.3
)
.