Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-17
Release Version 11-97
Removal and Replacement Procedures
RRP 2.1 Tray 1 Lift Up Motor (PL3.1)
Removal
1. Slide Tra
y
1 halfwa
y
out of the printer.
2. Remove the Rear Cover
(
RRP 1.3
)
.
3. Disconnect the J203 from the rear of Tra
y
1 Lift Up Motor.
4. Remove the three lon
g
screws securin
g
the Motor to the printer frame.
5. Slide the Motor out to remove it.
Replacement
1. Reinstall the Lift Up Motor onto the printer frame.
Be careful not to trap an
y
wires between the Motor and the frame.
2. Use three lon
g
screws to secure the Motor to the frame.
Use one screw on the lower left and two screws on the ri
g
ht side of the Motor.
3. Reconnect J203 to the rear of the Lift Up Motor.
4. Reinstall the Rear Cover
(
RRP 1.3
)
.
5. Slide Tra
y
1 into the printer.