Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-15
Release Version 11-97
Removal and Replacement Procedures
RRP 1.6 Rear Cover 1TM (PL1.3)
Removal
1. Disconnect all option plu
g
s from the Plu
g
Jack located at the rear of the printer.
2. Remove the two screws securin
g
the Rear Cover 1TM to the printer frame.
3. Lift up on the Cover and remove it from the printer frame.
Replacement
1. Reinstall the Rear Cover 1TM b
y
first hookin
g
the bottom ed
g
e of the Cover onto the frame, then
pressin
g
the top of the Cover a
g
ainst the frame.
2. Use two screws to secure the Cover to the printer frame.
3. Reconnect the option plu
g
s to the Plu
g
Jack located at the rear of the printer.