Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-11
Release Version 11-97
Removal and Replacement Procedures
RRP 1.4 Right Cover (PL1.3)
Removal
1. Remove the two screws securin
g
the Top Cover to the Ri
g
ht Cover.
2. Carefull
y
raise the ri
g
ht end of the Top Cover and at the same time lift the Ri
g
ht Cover up and awa
y
from the printer frame.
Replacement
1. Raise the ri
g
ht end of the Top Cover.
2. Press the Ri
g
ht Cover a
g
ainst the printer frame and slide the Cover down until the two hooks at the
bottom lip of the Cover are hooked in place under the Tra
y
1 Cover.
3. Press the top of the Ri
g
ht Cover a
g
ainst the printer frame while
y
ou lower the Top Cover.
Make sure the Top Cover screw tabs rest on top of the Ri
g
ht Cover.
4. Use two screws to secure the Ri
g
ht Cover
(
and Top Cover
)
to the printer frame.