Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-9
Release Version 11-97
Removal and Replacement Procedures
RRP 1.3 Rear Cover Assembly (PL1.3)
Removal
1. Remove the AC power cord from the rear of the printer.
2. Remove the two screws securin
g
the Rear Cover Assembl
y
to the printer frame.
3. Pull the bottom of the Rear Cover awa
y
from the printer frame and slide the Cover down to remove it.
Replacement
1. Slide the top ed
g
e of the Rear Cover under the ed
g
e of the Top Cover, then press the Rear Cover
a
g
ainst the printer frame.
2. Slide the Cover down so the bottom ed
g
e catches the lip of the printer frame.
3. Use two screws to secure the Rear Cover Assembl
y
to the printer frame.
4. Reconnect the AC power cord to the rear of the printer.