Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-7
Release Version 11-97
Removal and Replacement Procedures
RRP 1.2 Top Cover Assembly (PL1.1)
Removal
1. Unplu
g
the AC Power Cord from the rear of the printer.
2. Remove the Fuser Full Cover
(
RRP 1.1
)
.
3. Disconnect J204 from the Fuser Fan.
4. Remove the two screws securin
g
the ri
g
ht side of the Top Cover Assembl
y
to the Ri
g
ht Cover
(
Fi
g
ure
1
)
.
5. Carefull
y
lift the Top Cover a few inches off of the printer frame.
6. Disconnect the J417 from the Control Panel, and lift the Top Cover Assembl
y
off of the printer frame.
Replacement
1. Unplu
g
the AC Power Cord from the rear of the printer.
Do not reinstall the Top Cover while the AC Power Cord is connected to the
printer. While reinstalling the Top Cover you may accidently switch on the Main
Power Switch.
2. Reconnect J417 to the Control Panel.
3. Reinstall the Top Cover Assembl
y
onto the printer frame.
Make sure the screw holes at the ri
g
ht side of the Top Cover line up with the screw holes in the printer
frame, and the left end of the Cover is under the Exit Chute Pinch Rolls.
4. Use two screws to secure the Top Cover Assembl
y
to the Ri
g
ht Cover.
5. REconnect J204 to the Fuser Fan.
6. Reinstall the Fuser Full Cover
(
RRP 1.1
)
.