Service manual

QMS 3260/4032 Laser Printer - Base Engine Technical Manual 10-5
Release Version 11-97
Removal and Replacement Procedures
RRP 1.1 Fuser Full Cover (PL1.1)
Removal
1. Remove the Mailbox or the HCS if either are installed.
2. Open the Duplex Unit if one is installed.
3. Open the Left Upper Cover Assembl
y
and remove the screw securin
g
the Fuser Cover to the frame
(
Fi
g
ure 1
)
.
4. Open the Front Left Cover and remove the screw securin
g
the Fuser Cover to the frame
(
Fi
g
ure 1
)
.
5. Lift the Fuser Cover off of the Top Cover Assembl
y
.
Replacement
1. Open the Duplex Unit if one is installed.
2. Open the Left Upper Cover.
3. Slide the tabs that are located at both ends of the Cover into the correspondin
g
openin
g
s in the Top
Cover Assembl
y
(
Fi
g
ure 2
)
.
4. Lower the Fuser Full Cover onto the Fuser Assembl
y
.
5. Press the Fuser Full Cover into place.
Make sure the tabs remain in place, the Fuser Full Cover meshes smoothl
y
with the Top Cover, and
the two screw holes in the Fuser Full Cover line up with the holes in the printer frame.
6. Use two screws to secure the Fuser Full Cover.