Service manual

5-22 QMS 3260/4032 Laser Printer - Base Engine Technical Manual

Release Version 11-97

Primary Fault Isolation Procedures

5.9 Spots continued

Step Actions and Questions Yes No

FUSER INSPECTION

1. Generate another Blank Test Print and switch OFF printer

power when the print is halfway through the Fuser.

2. Open the Left Upper Cover.

3. Examine the paper areas before the image enters the

Fuser and after the image exits the Fuser.

Is paper clean before it enters the Fuser, but there are

spots on the paper when it exits the Fuser?

Replace the

Fuser Assem-

bly (RRP 6.1)

Clean or

replace the

Offset/Exit

Assembly

(RRP 7.1)