Specifications

$$
!$
"!$#&!$ *
""!"
$!
If the printer has warmed up and the Data indicator stays on, two problems may exist.
If you are downloading additional typefaces, too many can overload the printer’s
memory, causing the printer to reset and lose information previously downloaded to
RAM. Make sure you have enough printer memory.
On a LocalTalk network, Macintosh computers sometimes interfere with each other. If
this happens often, reinstall the LaserWriter and Laser Prep files, which reset the
printer. If neither of these is the problem, place a service call to your QMS vendor.
(# 1
If your printer prints a standard status page even though you’ve configured the printer
in the Administration/Special Pages/Status Page Type menu to print an advanced sta-
tus page, your printer probably doesn’t have enough free memory available. To print
an advanced status page you may need to reduce the amount of memory assigned to
one or more of the memory clients or add more memory (see the “Memory” section in
chapter 3, “Additional Technical Information,” in the
Reference manual for information
about memory clients).
(0 
If the Ready indicator is on, but no start-up page prints, check the following:
1 Has the start-up page been disabled?
Use the control panel to make sure the start-up page is enabled.
2 Did you wait long enough? From a cold start, the printer takes approxi-
mately 2-3 minutes to warm up.
Be sure you wait long enough for a start-up page before suspecting a problem.
3 Check that the paper trays are loaded with paper, in place and secure.
4 Check for a media jam.
5 Make sure a toner cartridge is installed.