Specifications

"&
!$
*
4 Is the printer printing codes or not printing at all when in ESP mode?
 Reconfigure the port to the specific printer emulation of the file you are
trying to print. See chapter 2, “Printer Configuration,” in the
Reference
manual for instructions.
 If a PostScript file prints PostScript statements while the printer is in ESP
mode, increase the ESP timeout. See chapter 2, “Printer Configuration,”
in the
Reference manual for instructions.
 If you continue to have problems with the ESP mode selecting the appro-
priate printer emulation, contact your QMS vendor.
!"
The toner cartridge is extremely sensitive to bright light and direct sunlight. Always
leave it in its protective bag until you are ready to install it. Any exposure to light
should be limited to two minutes. If you suspect the cartridge is damaged due to expo-
sure to light, put the it in a dark place to recover. Depending on the amount of expo-
sure, recovery may take up to two hours. Recovery time is dependent on the amount
of exposure sustained, and recovery is not guaranteed.