User`s guide

Function Instructs the emulation to begin decompression of the
image data using the currently set image options.
Syntax %%ImageData
Default None—no options.
Notes You must specify %%ImageSize before %%ImageData.
If you do not, the data following %%ImageData is
absorbed with no effect on the file.
This command begins reading the image data after the
end of the current line. After the image, the input stream
is flushed until the next set of %% characters is
encountered.
Function Sets the image position (in 0.001" increments) from the
upper-left corner of the page.
Syntax %%ImagePosition
(x y)
x
The horizontal location of the image’s upper-left
corner.
y The vertical location of the image’s upper-left
corner.
Default 0 0—Places the image in the upper-left corner of the
page.