Specifications

FrameMaker Ver.5.5(PC) Page Pro/Works 25 Troubleshooting
98.10.29
F-7
NOTE
The printer detects the following malfunctions. When it detects any of these malfunctions,
all elements are brought to an immediate stop except the fan motor.
JAM1 (Paper take-up misfeeds)
•
The Synchronizing Sensor is not activated after the lapse of a given period of time even
with two paper take-up retry sequences performed during paper take-up from the Multi-
purpose Tray.
•
The Synchronizing Sensor is not activated after the lapse of a given period of time even
with two paper take-up retry sequences performed during paper take-up from any of the
expansion cassettes (1st to 4th).
•
The Synchronizing Sensor is not activated after the lapse of a given period of time since
the start of the paper take-up sequence during single paper manual bypass feeding.
•
An LCC Paper Exit signal (EXIT) is not output even after the lapse of a given period of
time after a Paper Take-Up Request signal (FEED) has been turned ON during paper
take-up from the LCC.
JAM2 (Paper transport misfeeds)
•
When paper is fed from any of the expansion cassettes of 2nd to 4th and after the lapse
of a given period of time after the Paper Take-Up Sensor of the current cassette has been
activated, the Paper Take-Up Sensor of the next cassette (Synchronizing Sensor if the
next cassette is the 1st Cassette) is not activated.
•
The Paper Take-Up Sensor of the next cassette (Synchronizing Sensor if the next cas-
sette is the 1st Cassette) is not activated after the LCC Output signal has been turned
ON during paper take-up from the LCC.
•
When paper is fed from any of the expansion cassettes of 2nd to 4th, the printer recog-
nizes a paper length, in its paper length detection sequence, 260 mm or more longer
than the paper length data transmitted from the controller.
•
During a two-sided print cycle of paper fed from any of the expansion cassettes of 2nd to
4th, the printer recognizes a difference in paper length of ±20 mm or longer, in its paper
length detection sequence, between the detected paper length and the paper length data
transmitted from the controller.
JAM3 (Duplex Unit misfeeds)
•
The Synchronizing Sensor is not activated even after the lapse of a given period of time
after the paper has moved past the Duplex paper take-up point.
•
For the paper that is to be stored into the Duplex Unit, the DUP Sensor is not activated
even after the lapse of a given period of time after the Paper Exit Sensor has been deac-
tivated.
JAM4 (Fusing Unit misfeeds)
•
The Paper Exit Sensor is not deactivated even after the lapse of a given period of time
after the Synchronizing Sensor has been deactivated.
2
MALFUNCTION DETECTION
2-1. Misfeed Detection Conditions