Specifications

FrameMaker Ver.5.1(PC) SP-411 DISASSEMBLY AND CLEANING
98.07.21
D-5
2-3. Removal of the Circuit Boards
Parts Name Removal Procedure
Controller Board
(PWB-P)
Access Cover, Upper Cover, Front Cover, Left Cover, Harness Cover,
CN Cover, Rear Cover, Control Board Reinforcement Box (see 2-2.)
→
Remove eight screws, unplug one connector, and then remove
PWB-P.
Main Board
(PWB-A)
PWB-P
→
Remove four screws, unplug 14 connectors, and then
remove PWB-A.
Print Head Unit
(PH)
PWB-P
→
PWB-A
→
Control Panel
→
Remove five screws and the
handle.
→
Remove five screws and the left reinforcement plate.
→
Remove four screws and PH base plate.
→
Remove four screws and
PH.
Power Supply Unit
(PU1)
PWB-P
→
PWB-A
→
Control Panel
→
PH base plate
→
Remove
seven screws, unplug five connectors, and then remove PU1.
High Voltage Unit
(HV1)
Upper Cover
→
Open the Vertical Transport Door.
→
Remove the
Imaging Unit.
→
Using the long Phillips screwdriver, remove two
screws and the High Voltage Unit Cover.
→
Remove two screws,
unplug three connectors, and then remove HV1.
4108D005AA
PWB-P
PWB-A
PU1
Left Reinforcement Plate
Handle
PH
HV1