Specifications

FrameMaker Ver.5.1(PC) SP-411 A: PRODUCT INSTALLATION
98.07.17
A-1
When installing the printer, please avoid the types of locations listed below, both for safety
conditions and to breakdowns.
•
Which is exposed to direct sunlight.
•
Which is damp or dusty.
•
Where it may be splashed with water.
•
Which is tilted or subject to undue vibration.
•
Where it will be subject to extremely high or low temperature or humidity.
•
Where it will be subject to sudden fluctuations in either temperature or humidity.
•
Which is near volatile flammables or corrosive gas.
•
Which is in the direct air stream of an air conditioner, heater, or ventilator.
•
Which is near a TV set or radio.
In order to make sure the printer function s in good condition, please make sure ambient
environment satisfies the following requirements:
Do not plug the Power cord into a power outlet via an extension cord supplying electricity to
more than one unit.
When any other electric appliance is sourced from the same power outlet, make sure that
the current capacity of the outlet is not exceeded.
•
Ensure that the power outlet is not hidden behind any object, allowing the user to imme-
diately unplug the power cord when necessary.
•
The power-outlet shall be installed near the equipment and easily accessible.
•
The power cord should not be cracked or scratched.
1 PRECAUTIONS FOR INSTALLATION
1-1. Installation Site
1-2. Environmental Requirements
Temperature : 10 to 35°C Temperature fluctuation : ±10°C per hour or less
Humidity : 15 to 85% RH Humidity fluctuation : ±20% RH per hour or less
Altitude : 0 to 2500m Atmospheric pressure : 760 hPa or more
1-3. Power Requirements
Power source 120-127V, 50-60Hz 220-240V, 50-60Hz
Voltage fluctuation +6%, -10% ±10%
Frequency fluctuation ±3Hz