User`s guide

&RQILJXUHWKH
,QWHUIDFH
&RQQHFWLQJWRDQ(WKHUQHW1HWZRUN
1 In the Administration/Communications/Network x /CrownNet/
NetWare/Config PServer/PServer Context[1], PServer Con-
text[2], and PServer Context[3] menus, enter the name of the
configuration file server and print server context.
»Note: The three PServer Context[x] menus allow you to identify
the name of the NDS configuration file server and the print server
context.
The format for the option is
 File server name
 Space
 Print server context
For example, if the configuration file server name is QMS-4 and
the print server context is PRINTSERV2.SALES.QMS, you would
enter:
QMS-4 PRINTSERV2.SALES.QMS
»Note: Make sure to put a space between the file server name
(QMS-4) and the print server context
( PRINTSERV2.SALES.QMS).
Up to 16 characters can be entered in the Pserver Context[1]
field, an additional 16 characters in Pserver Context[2] field, and
16 characters in the Pserver Context[3] field.
»Note: If you want to assign more than 14 characters to the file
server name you must use CrownAdmin 3 to enter the name.
2 Reset the CrownNet interface by using the Administration/
Communications/Network x /CrownNet/Common/Soft Reset
menu.
3 You’re now ready to print.
From this point, you’ll probably perform most printing tasks from
your application. For specific information, check the printing sec-
tion in your application documentation.
For information on print media types and sizes, see chapter 2,
“Print Media,” in the Reference guide .