User`s guide

&RQQHFWWRWKH
1HWZRUN
406785%2 3ULQ W6\VWHP*HWWLQJ6WDUWHG
&RQQHFWWRWKH1HWZRUN
The method you use to connect your printer to the network depends
on whether you’re using a thin-wire, thick-wire, or twisted-pair Ether-
net connection.
 For thin-wire Ethernet (10Base2, BNC connector) see the next
section.
 For twisted-pair Ethernet (10BaseT, RJ45 connector) see page
4-6.
7KL Q :LUH (W KH UQHW &RQQHFWLRQ
Thin-wire Ethernet connections use BNC connectors.
s Caution: Unless the BNC “T” connector is already installed on the
thin-wire Ethernet cable, your network’s operation is disrupted during
the connection process.
1 Turn off the printer, and unplug the power cord.
2 If the BNC “T” connector is already installed, go to step 3.
Otherwise, attach one section of thin-wire Ethernet cable to
one end of the BNC “T” connector.
3 Attach another section of thin-wire Ethernet cable or a
50 ohm terminator to the other end of the BNC “T” connec-
tor.
4 Attach the BNC “T” connector to the BNC port on the Crown-
Net interface.
5 Plug in the printer, and turn it on.
%1& 2KP
7HUP LQDWRU
%1&o7p
&RQQHFWRU