Specifications

$ERXW+DUG

'LVNV

6WRUDJHDQG6FDQQLQJ'HYLFHV

&RQILJ XULQJ +DUG'LVNV

To configure the hard disk(s) you may need to either Enable Disk

Swap or increase the Disk Cache size, dependent on your printer’s

memory. (See the following section that applies to your printer mem-

ory).

After the Administration/Memory/Enable Disk Swap or Administration/

Memory/Disk Cache menu settings are reconfigured and the printer is

restarted, you need to print a status page to check that the Disk

Cache size is increased. (Notice that VM remaining memory is

also increased.)

6WDQGDUG0HPRU \

If your printer has only the standard memory, then you need to enable

disk swapping. See chapter 4, “Printer Configuration,” in the

Refer-

ence manual

for information on how to enable this option through the

Administration/Memory/Enable Disk Swap menu

DISK ONLINE prints on the status page if the printer recognizes the

disk(s). (See chapter 4, “Printer Configuration,” in the

Reference

manual, for information on how to print a status page.)

$GGLWL RQDO 0HPRU\

If your printer has additional memory, then you only need to increase

the Disk Cache size to 256 KB. See chapter 4, “Printer Configura-

tion,” in the

Reference

manual, for more information on increasing the

Disk Cache client’s size.

8VLQJWKH'LVN2SHUDWLRQV0HQX

The Administration/Disk Operations menu contains all of the options

you need to format a hard disk.