Specifications

$ERXW+DUG
'LVNV
6WRUDJHDQG6FDQQLQJ'HYLFHV
»Note: A Phillips screwdriver is needed for this procedure.
1 Position the controller board so that you’re looking at the
front of the interface panel.
2 Disconnect the serial cable, if previously installed.
Gently, pull straight up on the serial cable connectors to remove it
from the serial connector pins.
▲ Caution: Do not push or pull from the ribbon cable; use the cable
connector.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................