Specifications

$ER XW+ DUG
'LVNV
406785%2 3ULQ W6\VWHP2SWLRQV
9 Align the standoffs with the holes on the controller board.
So that you don’t stress the board, press one corner at a time to
secure the disk to the controller board.
10 Reconnect the serial cable, if previously installed.
See chapter 3, the “Installing an Optional Serial Interface” sec-
tion, and use the “Attach the Serial Interface” step.
5HPR Y L QJ DQ,QWHUQDO, '(+DUG'LV N
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks to the printer.
0 WARNING! Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲ Caution: This hardware change automatically restores defaults. If
your memory settings are specific for your environment, print an
advanced status page before making this hardware change, so you
can recover these memory settings.
It's very important to protect the printer controller board and other
circuit boards such as SIMM boards, the Multi-Res daughterboard,
and so on from electrostatic damage while performing this task.
Review the anti-static guidelines in “chapter 2, “Memory and System
Software,” the “Removing the Controller Board” section of this
manual.