Specifications

$ERXW+DUG
'LVNV
6WRUDJHDQG6FDQQLQJ'HYLFHV
5 Attach the IDE hard disk to the hard disk bracket.
Attach the IDE hard disk to the bracket with the grooved-end of
the bracket facing the ribbon cable.
The screw holes in the bottom of the hard disk should match up
with the holes on the hard disk bracket. Fasten the hard disk to
the bracket with the four screws provided in the kit.
6 Position the hard disk so that the four standoffs face the
controller board, the colored stripe on the ribbon cable faces
away from you, and the connector is down.
7 Insert ribbon cable connector pin 1 (colored stripe side of
cable) in hard disk connector pin 1, ensuring that all pins are
correctly aligned.
Caution: Make sure that the ribbon cable connector and the
controller board connector pins are properly aligned. Damage to
the controller board could result if the pins are misaligned.
8 Press down gently but firmly on the cable connector to seat
it on all the pins.
Caution: Do not push or pull from the ribbon cable; use the cable
connector.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................
,QWHUIDFH3 DQHO)URQW
5LEERQ
& DEOH,'(+DUG'LVN
*URRYHGHQGRI+DUG
'L VN%UDFNHW
6WDQGRII