Specifications

$ERXW+DUG
'LVNV
6WRUDJHDQG6FDQQLQJ'HYLFHV
:KDWVLQWKH.LW "
The IDE hard disk assembly kit includes the following:
 IDE hard disk with ribbon cable attached
 IDE hard disk bracket
 4 screws
,QVWDOOLQJDQ,QWHUQDO,'(+DUG'LVN
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks to the printer.
»Note: A Phillips screwdriver is needed for this procedure.
0 WARNING! Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲ Caution: This hardware change automatically restores defaults. If
your memory settings are specific for your environment, print an
advanced status page before making this hardware change, so you
can recover these memory settings.
It's very important to protect the printer controller board and other
circuit boards such as SIMM boards, the Multi-Res daughterboard,
and so on from electrostatic damage while performing this task.
Review the anti-static guidelines in chapter 2, “Memory and System
Software,” the “Removing the Controller Board” section.
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
2 Access the printer controller board.
Use the instructions in chapter 2, “Memory and System Soft-
ware,” the “Removing the Controller Board” section.