Specifications

.DQM L6,00.LW
6RIWZDUH
,QFUHDVLQ JWKH'LVN&DFKH6L ]H
To use the Kanji fonts with QMS 2425/2425 TURBO Print System’s
standard 12 MB of RAM you must do one of the following:
 Set the Administration/Memory/Manual/KMem/Disk Cache client
to 28 KB.
▲ Caution: The factory default for this memory client is 28 KB. If
this default has been changed to a value less than 28 KB, you
may need to decrease one of the other memory clients before
increasing the Disk Cache client. This option should be used only
by individuals who are familiar with adjusting memory settings.
Incorrect use of this option could cause your system to operate
incorrectly.
 If your printer has an optional hard disk, and if Administration/
Memory/Enable Disk Swap is set to On, then any extra memory is
distributed to all memory clients.
 Add more printer memory which automatically increases the Disk
Cache client’s memory setting. See chapter 2, “Memory and Sys-
tem Software” the ““Single In-Line Memory Modules” section, for
information on installing additional memory.
If your printer has more memory than 8 MB of RAM, the size of
the disk cache is adequate.
$FFHVVLQJWKH .DQML)RQWV
After you install the Kanji SIMM and configure the printer, you are
ready to access the Kanji fonts. From the list of sections below, locate
the section that matches your printer environment, and follow the
instructions to access the Kanji fonts.
 “If You are Using a Macintosh” on page 4-14
 “If You Are Using Windows” on page 4-16
 “If You Are Using DOS” on page 4-16