Specifications

,QVWDOOLQJWKH

0XOWL5HV

'DXJKWHUERDUG

406785%2 3ULQ W6\VWHP2SWLRQV

b Position the daughterboard over the plastic standoffs and the

80-pin connector (it should be facing you).

c Place pin-1 of the daughterboard into pin-1 on the controller

board, making sure that all other pins are correctly aligned.

Then gently press down on the daughterboard until the pins

are firmly seated.

▲

Caution: Make sure that the 80-pin connector on the

daughterboard and the 80-pins on the controller board are

properly aligned. Damage to the controller board could result

if the pins are misaligned.

d Snap the daughterboard onto the two support posts.

5 Replace the controller board.

Use the instructions in chapter 2, “Memory and System Soft-

ware,” the “Reinstalling the Controller Board” section, of this man-

ual.

6 Reconnect all interface cables and the power cord, and then

turn on the printer.

7 Check that Multi-Res is listed under “Options” on the start-

up page.

If not, you may have to repeat these procedures to make sure the

board is correctly installed.

...................................

..................

.......................................

3ODVWLF 6WDQGRII







