Specifications

,QVWDOOLQJWKH
0XOWL5HV
'DXJKWHUERDUG
,QWHUIDFHVDQG'DXJKWHUERDUGV
,QVWDOOLQ
J
WK H0XOWL5HV
'DX
J
KWHUERDUG
:KDWV LQWKH.LW"
 Multi-Res daughterboard
 2 plastic support posts
3U RFHGXU H
0 WARNING! Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲ Caution: It's very important to protect the printer controller board and
other circuit boards such as SIMM boards, the Multi-Res
daughterboard, and so on from electrostatic damage while
performing this task. Review the anti-static guidelines in “Installing an
Optional Network Interface” on page 3-3.
1 Turn off the printer, and then disconnect the power cord and
all interface cables (parallel, Ethernet, and so on, if installed)
from the printer.
2 Access the printer controller board.
Use the instructions chapter 2, “Memory and System Software”
the “Removing the Controller Board” section, of this manual.
3 Position the controller board so that you’re looking at the
interface panel.
4 Attach the Multi-Res daughterboard.
a Snap the two plastic standoffs into the controller board.