Specifications

2SWLRQ DO6HULD O
,QWHUIDFH
,QWHUIDFHVDQG'DXJKWHUERDUGV
%DXG5DWH
Sets the rate data is transmitted (bits per second) over the serial inter-
face.
3D ULW\
Sets the check bit used to identify data transmission errors.
,JQRUH 3DUL W\ (UURUV
Specifies how the printer should handle parity errors.
Menu Administration/Communications/Serial/Baud Rate
Choices 300, 600, 1200, 2400, 4800, 9600, 19200, 38400
Default 9600
Notes Baud rates of 19200 and 38400 require hardware flow
control (Administration/Communications/Serial/Hdwe
Flow Ctl menu).
Menu Administration/Communications/Serial/Parity
Choices None, Odd, Even
Default None
Notes The printer’s parity setting must match that of the host
or application.
Use the Administration/Communications/Serial/Ignore
Parity menu to specify how the printer handles parity
errors.
Menu Administration/Communications/Serial/Ignore Parity
Choices Off—Ignore parity errors. The printer prints its best
interpretation of the character(s) affected by the error.
On—Don’t ignore parity errors. The printer replaces the
character(s) affected by the error with a question mark.
Default Off
Notes Use the Administration/Communications/Serial/Parity
menu to set parity.