Specifications

2SWLRQDO
/RFDO7DON
,QWHUIDFH
406785%2 3ULQ W6\VWHP2SWLRQV
2SW LRQ DO/RFDO7DON,QWHUIDFH$VVHPEO\.LW
The optional network interface assembly kit includes the following:
 A LocalTalk interface card
 LocalTalk interface notice
The kit may also include additional parts not required for interface
installation on this printer.
»Note: A Phillips screwdriver is needed for this procedure.
,Q VWDOOLQJDQ  2S WLR QDO / RF DO7D ON ,Q WHU ID FH
0 WARNING! Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲ Caution: It's very important to protect the printer controller board and
other circuit boards such as SIMM boards, the Multi-Res
daughterboard, and so on from electrostatic damage while
performing this task. Review the anti-static guidelines in chapter 2
““Memory and System Software,”the “Removing the Controller Board”
section, of this manual.
1 Turn off the printer, and then disconnect the power cord and
all interface cables (parallel and Ethernet) from the printer.
2 Access the printer controller board.
Use the instructions in chapter 2 “Memory and System Software,”
the “Removing the Controller Board” section, of this manual.
3 Remove the two screws from the optional interface plate.
Save the two screws. (You’ll use them when you install the
optional interface card.) You can either save or discard the plate.