Specifications

2SWLRQDO
1HWZRUN
,QWHUIDFH
406785%2 3ULQ W6\VWHP2SWLRQV
4 Attach the network interface card (NIC).
a Position the NIC so the port slides into the opening you just
created.
b Snap the NIC onto the 80-pin connector on the controller
board.
c Press down on the board gently until it is secured by the 80-
pin connector and by the plastic standoff post.
5 Replace the controller board.
Use the instructions in chapter 2 “Memory and System Software,”
the “Reinstalling the Controller Board” section, of this manual.
6 Secure the NIC to the printer with the two screws you
removed earlier.
7 Reconnect all interface cables and the power cord, and then
turn on the printer.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................