Specifications

6LQJOH,Q/LQH
0HPRU\
0RGXOHV
406785%2 3ULQ W6\VWHP2SWLRQV
1 Access the printer controller board.
Use the instructions in the “Removing the Controller Board” sec-
tion earlier in this chapter.
0 WARNING! Turn off the printer and unplug the power cord before
removing the printer’s controller board.
ACHTUNG! Schalten Sie unbedingt den Drucker aus und ziehen
Sie den Netzstecker bevor Sie den Controller aus dem Drucker
nehmen.
2 Position the controller board on a flat surface so the
controller board lies flat and the bracket is facing you.
3 Remove the SIMM from the anti-static bag.
4 Insert the SIMM into the SIMM connector.
Hold the SIMM at a 45° angle to the controller board, with the
notch on the right side and the bottom edge is in the connector.
»Note: Insert a SIMM in either SIMM connector as long as
DRAM0, and the SIMM connector before the one you’re installing,
is occupied.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................