Specifications

4060RGHO

6WDFNHU

'RFXPHQW)LQLVKLQJ2SWLRQV

10 Printing and stapling will resume normally, unless the sta-

ples do not advance correctly.

If the staples are not advanced, any print job that was being sta-

pled when the staple out condition occurred may not be stapled

correctly. Take one of the following actions:

 Continue printing the job. (You may want to do this if you’re

printing a large job.)

»Note:

If the staples are not advanced to the correct position,

the printer will advance the stapler once for each staple job

received; so several copies of your stapled sets may not be

stapled correctly. If the print engine detects that a test staple

is needed, the next calibration page, status page, or startup

page printed will serve as the test staple job, and up to 10

test staples will be placed along one side of the page. If the

staples are advanced to the correct position, the next staple

job will be stapled correctly.

 Print a test staple job to advance the staples to the proper

staple position.

Press the Print Status key on the control panel, and select

Yes. A standard or advanced status page prints. Up to 10 test

staples will be placed along one side of the status page. The

printer is now ready to resume normal operation.

4060RGHO6WDFNHU

The QMS Model 3100 Stacker for your QMS 2425/2425

TURBO

System gives you the ability to stack up to 3100 letter-size sheets face

down. Attaching this stacker enables you to print large jobs without hav-

ing to remove 500 sheets from the face-down output tray when it fills.

»Note:

There are two stackers available. One works with only 8.5"x11"

paper, and the other works only with A4 paper. Make sure that your

print job is set up to print only on 8.5"x11" paper or only on A4 paper.

The stacker will jam if other paper sizes are selected.