Specifications
6WDFNOHU
'RFXPHQW)LQLVKLQJ2SWLRQV
2 Plug the printer’s power cord into the power connector on
the printer, and plug the Stackler’s power cord into the power
connector on the Stackler (at the left-rear side of the
Stackler).
»Note:
Remember that only the printer’s and the Stackler’s power
cords are connected when using the pedestal stand.
3 Insert the remaining cord into the cable holder, letting the
plug ends hang free.
4 Plug the power cords into the power outlets.
▲ Caution:
Make sure that the printer is turned off. Do not confuse
the Stackler’s, input paper deck’s, and printer’s power cord. Use
of the wrong cord could damage the Stackler.
5 Turn on the Stackler and high-capacity paper deck, if
installed, and then turn on the printer.
6WD FNOHUSRZHUFRUG
3UL QWHUS RZHUFRUG
3DSHUGHFN
SRZHUFRUG