Specifications

6WDFNOHU

406785%23ULQW6\VWHP2SWLRQV

&RQQHFWWKH&DEOHV
Before you can use the Stackler you need to connect the data cables
and install the option controller board, if it is not already installed. The
Stackler has two I/O sockets, one for input (IN) and one for output
(OUT).
0 WARNING! Turn off the printer and unplug the power cord before
connecting any cables.
ACHTUNG! Schalten Sie bitte den Drucker aus und ziehen das
Netzkabel heraus, bevor Sie andere Kabel an den Drucker
anschliessen.
1 Connect one end of the data cable (supplied with the Stack-
ler) into the upper socket on the Stackler and secure the plug
by turning the two screws clockwise.
»Note: The I/O sockets are underneath the Stackler on the side
opposite the output trays.
This socket... Uses this type plug... To connect the ...
Upper (IN) 15-pin Printer
Lower (OUT) 14-pin Additional Options
6WDFNOH UnV
XSSHUVRFNHW
3DSH UGHFNnV
ORZHUVRFNHW