Specifications

,QVWDOOLQJ
&URZQ&RS\
6WRUDJHDQG6FDQQLQJ'HYLFHV
d Pull up the input paper chute extension.
6 Turn off both the scanner and the printer, if necessary.
7 Plug the power cord into the scanner and a power source.
8 Set the SCSI ID setting.
Using a small, flat-head screwdriver, set the rotary switch on the
back of the scanner to SCSI ID 5.
9 Connect the scanner and the printer to the SCSI bus in either
of the following ways, based on your equipment setup.
Connect only the printer and the scanner.
a Plug in the male side of the SCSI terminator to the
scanners SCSI connector.
b Attach one end of the SCSI cable into the terminator and
the other end of the cable to the printer.
0H WDO%UDFNHW
3DSHU&KXWH
6FDQQHU
 3ULQW 6\VW HP
7HUPLQDWRU
6&6,&DEOH