User`s guide

Prints zeros with or without slashes.

Sets the vertical MAGNUM correction.

» Note:

This option is provided for users of the Code V Version I

programming language. If you modified programs that utilized rotated

MAGNUM characters in Code V Version I to compensate for

elongated characters caused by the 60 x 72 dot matrix used by

impact printers, then set this option to On.

In Code V version II, there is no elongating of rotated MAGNUM char-

acters. Set this option to On if you wish to send your existing Code V

Version I programs to the printer unchanged. If you don’t have Code

V Version I programs, or if you didn’t encounter elongated MAGNUM

characters, then leave this option set to Off.

Default One Character

Notes All characters are absorbed until line termination is set to

one or two lines.

Administration/Emulations/MAGNUM/Code V Setup/Slash In 0

Choices Enable—Prints a slash in the zero (ø).

Disable—Prints a zero with no slash (0).

Default Enable

Administration/Emulations/MAGNUM/Code V Setup/Vertical MAG COR

Choices On—Adjusts the dots per inch to match the printer.

Off—Doesn’t adjust the dots per inch.

Default Off