Setup guide

13
2 At the computer, use the telephone cable (included
with the fax modem) to connect the jack labeled
Line on the fax modem to a phone jack in the wall
(where you would normally plug in your phone). If
the fax modem jacks aren’t labeled, see the fax
modem documentation to see which one you should
connect to the wall jack.
3 If you want to use the same telephone line to make
voice calls when the fax modem is not in use, plug
your phone (or another analog device, such as an
answering machine) into the second jack on the fax
modem.
The Fax Server is set up to answer the line on the first ring,
but if you use the same line for faxing and voice calls, you’ll
probably want the Fax Server to wait a few more rings before
answering. You can change this setting in the 3 UHIHU HQ FHV
dialog box (choose 3UHIHUHQFHV from the 2
S
WLRQV menu in
QMS Manager when you start it for the first time). Choose the
+HO
S
button for information on options in that dialog box.
4 Connect the 2001 to a grounded electrical outlet.
Make sure the electrical outlet you connect the system to is a
properly grounded (earth connection) outlet, running 120
VAC, 50-60 Hz (if you have a 110V unit), or 230 ±10 VAC, 50
Hz (if you have a 220V unit). The system should be directly
connected to an outlet.
5 Turn on the 2001. When the Ready light stops blink-
ing, the system is ready to use.
ÅÎ@  ÌÎ  kÌ  Þ k b k Ì/àÅÎkÌ/xÎ Þ @Âk
2
Caution:
We recommend that you make backup copies of all of
the disks, store the originals in a safe place, and use the copies to
install the software. One way to do this is to open the Windows
)LO H
0DQDJHU
and choose
&R
S
\'L VN
from the
'L VN
menu. Choose
+HO
S
in the dialog box that appears for more information.
Installing the QMS Manager Software
Note:
You cannot install the software by copying files from
the disks. You must run the setup program.
1 With Windows running, insert Disk 1 of the Knowl-
edge System software in a 3.5" disk drive at the com-
puter.