Setup guide
9
4 Unfold the scanner-tray extension and slide the
scanner-tray flaps (under the tray) together.
5 Install the output tray: set the two tabs on the bottom
of the tray into their slots as shown below.
6
If you have a Knowledge System peripheral unit, con-
tinue with “Installing the Fax Modem in the Com-
puter” below. If you have a Knowledge System
PC
,
skip to “Connecting the Knowledge System PC” on
page 18. If you are connecting a Knowledge System
to a computer that already has a fax modem
installed, skip to “Connecting the Knowledge System
Peripheral Unit” on page 12
.
ÅÎ@ÌÎkÌ@ßÌ!bkÌÌÎkÌ ×ÎkÂ
This procedure requires you to install a circuit board in your com-
puter and possibly to change some computer settings, so you’ll
need to refer to your computer’s documentation for some informa-
tion. If you feel uncomfortable about performing these procedures,
you might want to get an experienced person to help you.
1 Use Microsoft Diagnostics (MSD) to find out which
COM settings are in use on your computer: Exit Win-
dows (if necessary) and at the DOS C:\ prompt, type
msd, press Enter, and then choose the COM Ports but-
ton in the screen that appears.
6FDQQ HU7UD\
)ODSV
6FDQQHU7UD\
([WHQVLRQ
2XWSXW7UD\
6ORWV