Specifications

printer to recognize them. See your font documentation for down-
loading instructions.
If you experience problems with fonts not downloading correctly, the
printer may have run out of memory while downloading the fonts,
macros, and/or patterns.
Add more memory to the printer, which automatically increases
the Disk Cache client’s size. See chapter 6, “Printer Options,” of
the
Reference for information on installing SIMMs.
Take any memory, if available and not being used by other cli-
ents, and add it to the Administration/Memory/K Mem Disk Cache
client.
▲ Caution : This option should be used only by individuals who are
familiar with adjusting the values of the printer’s memory clients.
Incorrect use of this option could cause the printer to operate
incorrectly.
Decrease the number of fonts you’re downloading, or when
downloading a large number of fonts, packet them in smaller
groups (for example, download only four fonts at a time instead of
eight).
Remove some of the downloaded fonts from the print system,
using PS Executive or QMS Document Option Commands
(DOC).
If the printer has an optional hard disk, set the Administration/
Memory/Enable Disk Swap menu to On. Any extra memory is dis-
tributed to all memory clients.
If you’ve installed the Intellifont PROMs, but the Intellifonts aren’t
listed on the printer start-up and advanced status pages, check the
following:
Are the controller board connectors firmly seated?