Technical information

Printer Start-Up Options ............................................................4-85
Enabling/Disabling the Start-up Page 4-85
Enabling/Disabling the SYS\START File 4-86
Loading the PostScript Error Handler 4-86
Special Pages .............................................................................4-86
Using the Calibration Page 4-87
Working with Status Pages 4-87
Working with Header Pages 4-89
Working with Trailer Pages 4-90
Timeouts .....................................................................................4-91
Setting an Emulation Timeout 4-91
Setting an ESP Timeout 4-92
Setting a PostScript Emulation Timeout 4-92
Setting a Print Job Timeout 4-93
Setting a Manual Feed Timeout 4-93
Introduction ..................................................................................5-2
Communication Modes ................................................................5-2
About Gamma Correction ...........................................................5-2
Terms 5-2
Gamma Correction Concept 5-6
A Special Note for QuarkXPress Users 5-7
Memory .........................................................................................5-8
QMS Memory Management 5-9
Memory Terms 5-9
Evaluation of Your Printing Environment 5-13
Memory Clients 5-14
End Job Mode .............................................................................5-21
Common Reasons to Use End Job Mode 5-22
Using the EOD Commands 5-23
Setting the End Job Mode for the Serial and Parallel Protocols 5-24
Setting the End Job Mode via the Control Panel 5-25
Adding an EOD Command to Your File 5-27
Creating a Network Job Separator 5-28