Technical information

3 Release the SIMM.
Pull the latches on each side of the SIMM connector outward
using both thumbs.
4 Remove the SIMM.
Tilt the SIMM backwards to a 45° angle away from the SIMM con-
nector, and then lift it out.
5 If you want to install a SIMM, refer to “Installing a SIMM,” ear-
lier in this section, otherwise continue at step 6.
6 Reinsert the controller board in the printer.
Use the instructions in the “Reinstalling the Controller Board” sec-
tion, earlier in this chapter.