Product guide

22
1. Send the shade to Top/Upper limit.
2. Press & Hold the UP button after the shade has stopped.
3. After about 5 seconds the shade will Jog down 75mm and back up.
Keep holding the UP button, do not release.
4. After about 10 seconds the shade will start traveling to the 75% position.
Keep holding the UP button, do not release.
5. After about 15 seconds the shade will begin to travel to the Default Shade
Length. (About 500mm). Release the UP button.
a. When the shade stops it will be ready to perform a Factory Reset.
b. Tug the shade more than 150mm within 10 seconds of the shade
stopping to perform a Factory Reset.
c. The Factory Reset will, delete all remotes from the shade memory, and
reset all programmed positions to Factory Default settings.
d. The shade will be in learn mode for adding new remotes for one minute.
e. Press and Hold the Up Button on a new remote or channel until the shade
begins to move Up.
f. If a new remote is not added within one minute, the shade will exit Learn
Mode for Remotes and can only be operated through tugs. A new remote
can only be added by performing
i. 2 Button Press procedure with a Multichannel remote or
USB remote.
ii. Removing and re-applying power to the shade, followed by
step e. of this section.
Factory Reset Then Adding a Remote
QMotion UK Remote Settings
For shades produced on or after April 15th, 2013.
Product Guide 2014 NEW.indd 25Product Guide 2014 NEW.indd 25 14/01/2014 15:0214/01/2014 15:02