Product guide

20
Setting Any Position Location
QMotion UK Setting Hembar Position
For shades produced on or after April 15th, 2013.
QMotion UK shades produced after April 15, 2013 have the additional
ability to program the upper stop position. These instructions may be
followed the same for each button programming operation, substituting
the desired button to be programmed during this process.
1. Send the shade to the position to be changed.
2. Press & Hold the button desired to be changed after the shade has stopped
(eg. if the position to be programmed is the upper limit, press and hold
the UP button)
3. After about 5 seconds the shade will Jog down 75mm and back up.
a. Release the position button to be changed.
b. Tug the shade 150mm to enter learn mode for the button position.
c. Move the shade to the new position by hand or press the UP button
3 times to send the shade to the TOP, then pull down to the desired
position.
d. Press and Hold the position button to be set until the shade begins
to move UP.
e. The shade will travel to the “hard stop”, the new position has been set.
Product Guide 2014 NEW.indd 23Product Guide 2014 NEW.indd 23 14/01/2014 15:0214/01/2014 15:02