Installation Guide

SELECTION CHART

Model

Number Description

Single Pole Snap Action Thermostat Assembly.

Rating - 25 Amps at 120V through 277 VAC.

NOTE: Thermostat Comes Assembled to End Cap.

Double Pole Snap Action Thermostat Assembly.

Rating - 25 Amps at 120V through 277 VAC.

NOTE: Thermostat Comes Assembled to End Cap.

T1TPH Same as Model T1 Except Tamperproof Version.

T2TPH Same as Model T2 Except Tamperproof Version.

OPERATION CHECK

1. After your electric baseboard heating system has been com-

pletely installed, all thermostats, whether mounted on the

wall or in the baseboard, should be turned to “LOW” or “OFF”.

Then turn on breakers or install fuses. Wait 3 to 5 minutes

and check to see that none of the heaters are operating.

Should any of the heaters be operating, disconnect power

and check your wiring. If none are operating, then turn the

thermostats to the highest position and wait another 3 to 5

minutes. Then check to see that all heaters are in operation.

Should any not be operating, again disconnect power and

check your wiring.

2. Allow entire system to operate steadily for 1/2 hour. This

should remove all residue from manufacturing. (Some smok-

ing may occur).

3. Select the setting for your comfort on all thermostats.

4. Your electric heating system has many advantages, one of

which is zone or room by room control. If you desire to keep

a seldom used room at a lower temperature this may be done

by lowering the thermostat setting and closing the door.

However, DO NOT try to control different rooms at different

temperatures unless the doors are kept closed. This will tend

to increase operating cost and decrease comfort. It is advis-

able, if rooms are kept open, that all thermostats have the

same setting. By following these instructions you will enjoy

greater comfort.