User guide

© 2011 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Cisco Validated Design Page 100
5. To install XenServer on the SAN select any of the available ―NetApp LUN‖ drives, i.e. ―sdc – 50 GB
[NETAPP LUN]‖.
6. At the end of the XenServer installation you are prompted for the QLogic driver supplemental pack;
connect the QLogic .iso using the KVM Virtual Media and select OK. Following the installation screens as
normal and when finished you will be prompted for any additional supplemental packs, if you have none
press skip to complete the installation.
Note: For XenDesktop the Linux supplemental pack is not required thus not installed, if required mount to Virtual media and
install.
7. Click ―OK‖ to complete the installation and reboot the server.
5.8.1 XenServer Networking
Storage traffic can be separated from Management traffic by configuring an additional Management Interface on
each XenServer (since the VDA servers have 4 physical NICs this approach was used), with an IP address
assigned on the Storage network VLAN (166). On the NetApp controllers, only these IP addresses are given
permissions to access the relevant volume; which stops the storage traffic going over the default management
NIC and also helps ensure that storage traffic is not routed.